Make Waterproof Matches

Waterproof or water-resistant describes objects unaffected by water or resisting water passage, or which are covered with a material that resists or does not allow water passage. Such items may be used in wet environments or under water. Waterproofing describes making an object waterproof or water-resistant. Here are some of the tips for making a thing waterproof

All the below methods involve some risk. If you are a minor, do not carry out any of these activities, without the permission of a competent adult supervisor.

  Use Turpentine

The BEST & SAFEST Method is to use Turpentine. (Turpentine has a higher "flash point" relative to Acetone, which commonly used in Nail Polish. Nor does it involve the use of flame as is needed in the Wax or Paraffin methods.)

   1. Pour 2 to 3 large tablespoons of Turpentine into a small (Tumbler sized) glass.
   2. Place the matches, (Head down) into the Turpentine and allow the matches to soak for 5 minutes. During that time the turpentine will soak into the head as well as the stem. All the water will be driven off by the turpentine.
   3. Remove the matches and spread them out to dry out on a sheet of newspaper. Generally, 20 minutes for excess turpentine to be evaporated is recommended. Matches treated in this way remain waterproof for several months or longer.
 

 Use Nail Polish

   1. Dip the head end of the match into clear nail polish far enough to cover at least an eighth of an inch (3 millimeters) of the stick below the head.
   2. Hold the match for a few seconds to allow the polish to dry and then place the match on a table or counter so that the head is suspended off the edge of the surface.
   3. Place a sheet of newsprint below to catch anything that may drip off.
 

 Use a Candle

   1. Light a candle and let it burn down until you have a good amount of liquid wax (about a half of an inch or 1 centimeter).
   2. Extinguish the candle.
   3. Dip the head end of the match into the wax far enough to cover at least an eighth of an inch (3 millimeters) of the stick below the head.
   4. Hold the match for a few seconds to allow the wax to harden slightly and then place the match on a table or counter so that the head is suspended off the edge of the surface.
   5. When the wax has cooled, but not completely hardened, pinch the end of the wax coating (towards the stick), forming a tight seal.